11.4.9. Dismantling and assembly of an electronic and adjustable steering column
Dismantling and assembly of an electronic and adjustable steering column
Elements of adjustment of a steering column
|
The motor of shift of the steering column M20 (on a steering column) |
|
The motor of adjustment of the telescopic steering column M20m1 (on a steering column) |
Dismantling
|
1. Remove a steering column. 2. Remove an epiploon 71s from the lower part of a steering shaft. 3. Disconnect the lower steering shaft 80a. |
|
Check
|
1. Check a cross beating of the lower steering shaft 80a. 2. Remove the lower arm 82. 3. Install height regulator in average situation. 4. Remove the drive of adjustment of an inclination of a steering column (top / down) M20m2 5. Remove the telescopic drive of adjustment (in/outside of) M20m1. 6. Remove an emphasis of a steering column 83. 7. Remove an arm 85. 8. Turn off a bolt of the 86th fastening of a cover and take an internal pipe from an external pipe down. 9. Sort an internal pipe. |
|
Assembly
|
1. Collect an internal pipe. 2. Grease an internal pipe 81b and insert it from below into an external pipe. 3. Turn in directing a bolt 86, having combined a groove on an internal pipe 81b with a bolt. 4. Install the telescopic drive of adjustment (in/outside of) M20m1. 5. Further assembly is carried out as it should be, the return to removal. The most admissible beating of the lower steering shaft: 2.0 mm. |
|