1. The driveshaft with connections is presented on an accompanying illustration.
2. Lift the transmission by means of a jack.

3. Turn off a nut of fastening of a support of the engine 35. Turn off bolts 21 with washers and remove an engine 19 arm together with a support 18.

4. Unscrew the driveshaft from the transmission. Turn off a bolt of the 8th fastening of a shaft of a speedometer 9 and remove it.

5. Weaken adjusting plugs in Cardan's flange. For this purpose use a drift with a diameter of 10 mm and about 150 mm long.

6. Weaken a nut of the driveshaft and move the driveshaft from a flange towards a back part of the car.

7. Turn off bolts 200a.

Installation is made upside-down.